Use painter s tape to isolate the part of the floor where the compound has dried so that you don t get any adhesive remover on the part of the floor that is not covered in the compound.
Remove dried spackle from floor.
If after drying a white film remains on the surface of the floor wipe it up again with a fully rinsed out sponge.
If you need to scrape dried mud from your hardwood floor use a.
Chip off large chunks of spackling with a small metal putty knife.
Pour an anti mastic or adhesive remover onto the area where the spill occurred if the compound has dried.
Step 3 sand the remaining spackling in a circular motion with a piece of 120 or 150 grit sandpaper.
Wipe the area dry with a dry clean towel to eliminate any spackle residue.
Scrape the blade of the knife gently against any ridges to remove them.
To avoid scraping try wetting a towel and let it sit on the spackle for an hour or so to loosen it up.
Spackle is a ready to use compound used for holes cracks and imperfections in plaster wallboard wood painted metal and masonry.
If plain water on the rag doesn t do the trick progress to a gentle cleanser.
You can easily scrape it off any hard surface.
Apply spackle with a putty knife.
You do not need to prime over a hole repaired with spackle unless you are spackling an exterior area.
Step 3 scrape up dried bits of spackle stuck to the floor using a plastic putty knife.
Angle the knife about 45 degrees and run it in downwards motions until the hole is filled.
If it is in the grout use a stiff brush and water.
The moisture might soften the paint enough so that you can then scrape it off says estabrooke.
If it has gone into the grain use and infant toothbrush to get in the grain of the wood.
Work spackle dots off with the plastic blade of the applicator the toothpicks and the plastic pot.
Next use a damp rag over the dried paint if the scraping doesn t remove the drip try rubbing the surface of the paint with a damp not wet rag.
It dries very quickly and is considered to be shrink free.
Usually spackle is water based and can be removed with water and gentle rubbing.